搜索
CN
News
Your Location:
Homepage
-
-
-
Two-piece clean suit changing process, come and collect

Two-piece clean suit changing process, come and collect

Two-piece clean suit changing process, come and collect

(Summary description)

Information

Drug safety is related to everyone's health and life safety. As an indispensable tool in the pharmaceutical process, the scientific and standardized management of clean clothing is an important means to effectively reduce pollution. As an important part of the clean clothes management process, the changing process of clean clothes has been paid more and more attention.
For the work environment that requires the wearing of clean clothes, there are standardized procedures for the wearing of clean clothes. In the case of Capelliton's two-piece clean suit and clean underwear, the following dressing steps should be followed when wearing:
Before entering the aseptic operation area A and B for aseptic dressing, clean personnel should wear the uniform and work shoes of the general area or the C and D area.
When cleaning personnel enter the clean area, they should not wear any accessories and are not allowed to make up; Women should tie up their long hair.


One watch room
(1) Take off non-sterile work shoes, put them in the locker, and change into slippers.
(2) Take off non-sterile work clothes and hang them on a hanger.
(3) Cleaning hands and arms: special cleaning products need to be used to clean and dry the hands and arms, and then alcohol disinfection, to ensure that the maximum extent of the removal of pollutants.


Two Angle room

(1) Hand disinfection, and then wear sterile gloves.
Remember: Do not let your skin touch the outer surface of the gloves during the whole process.
(2) More sterile underwear: hand disinfection first, remove sterile underwear from the clean bag, grasp the outer surface of the underwear with the hand, wear the top after the pants, and then in front of the mirror to arrange the clothes and hats. During the whole process, the outer surface of the underwear should not touch the body and the ground to reduce the spread of pollutants.
(3) Take off gloves and slippers, disinfect hands again and enter the Sanjian room.


Three watch room


(1) Wear gloves, wear high tube shoe cover: hand disinfection first, put on the second pair of sterile gloves, hand disinfection again, change into high tube shoe cover, zipper to two-thirds of the shoe tube. Note: Sterile gloves should not touch the outer surface of the leg and the upper shoe cover when wearing the upper shoe cover. At the same time, the high shoe cover should not touch other objects.

(2) Wearing the shawl cap: disinfect the hands first, remove the shawl cap from the sterile pocket, hold the bottom of the shawl cap inner surface to the mirror finishing, until the most appropriate position. It should be noted that the hair must be up and tucked completely inside the hat.

(3) More sterile outerwear: hand disinfection, remove sterile outerwear from the clean bag, reach to the inner surface to adjust the height of the outerwear, while ensuring that the outerwear does not contact the ground.
Keep your hands steady as you pass through the pant leg. Once you've pulled on the pant leg, look in the mirror and find the cuff. Then reach in with both arms, lean forward and push your arms slightly, and push your thumbs through the pull loop at the end of the sleeve.
Sleeve and back, hat and back are connected with the hidden button, can prevent the clothes are too long and lead to the ground.
(4) Finishing the shawl cap: During the adjustment process, hands should not touch the outer surface of the coat, but only the lower part of the shawl cap (this part will eventually be covered by the coat), until the shawl cap is placed under the coat, zipper up, and buckle the buckle of the outer collar.
Note: Once the outer surface of the sterile coat touches the wall and ground, it should be re-disinfected before use.

(5) Finishing high tube shoe covers: first hand disinfection, then wear high tube shoe covers. By holding the inner surface of the shoe tube roll the shoe tube to the ankle, hold the inner surface of the pant tube with both hands, open the button on the pant leg, pull the pant tube down to the end, tighten the dark QQ in front of the pant, find the pull ring, pull up, zip up and buckle the button. The whole process as much as possible to reduce the contact with the outer surface of the pant and shoe cover.


(6) Wear a sterile mask: Sterilize your hands first and take out the sterile mask from the upper part of the sterile pocket. It should be noted that your hands can only touch the strap of the mask. Make sure that the upper and lower orientation of the mask and then wear it. The plastic bar can be adjusted closely to the bridge of the nose, and the fingers should not touch the face.
(7) Wearing an eye mask: disinfect your hands first, take out the eye mask from the eye mask bag, tighten the eye mask band to both sides of your hands, and insert the card slot to ensure that no skin is exposed outside. Note: Before wearing, adjust the headband size of the eye mask.

(8) Spray disinfection: All clothes need to be sprayed after wearing. Spray all places that may be encountered in the wearing process, including the head, arms, chest, legs, feet and so on. Finally, please check your dress properly through the mirror.
Disinfect your hands again and put on sterile gloves. It is important to note that once the last pair of gloves is on, you should not touch any more objects.
After everything is ready, you can enter the A and B sterile area to work.
In our last article, "Do you Really Understand the Triplet Cleaning Suit Changing Process", we detailed the triplet cleaning suit changing process and precautions. You should note that the changing process of the two-piece clean suit is similar to that of the three-piece clean suit. The difference is that the two-piece clean suit needs to wear a shawl cap.

The dressing procedure for the personnel entering the A and B aseptic areas is very complicated. In order to avoid contamination and effectively control risks, personnel dressing training and dressing procedure verification are very necessary. Pharmaceutical companies should develop specific, detailed and clear written dressing procedures and train relevant staff. At the same time, the relevant personnel shall be assessed and qualified before the actual dressing procedure can be implemented.
To ensure the quality and safety of drugs is the responsibility and obligation of every drugmaker. Love and dedication, strict in law, do every little thing, control every link, for the quality and safety of drugs escort.

Scan the QR code to read on your phone

Related News

Quick Navigation

Site Map  |  Contact  |  Privacy Statement

Contact Us

 

Add: Building 3, Qiyate Center, Minhang District, Shanghai

Production base: Building 8, Qiyate Center, Minhang District, Shanghai

Email: shjiabo@vip.sina.com

Hotline: 021-64119930/64119931/64119932

微信公众号

Scan and follow us

  Copyright © 2020  Shanghai Jiabo Litong Technology Co.,Ltd   沪ICP备14039856号      Powered by:300.cn